г.Киев, ул. Красноармейская 30-Б, оф.11
 тел. +38 (044) 238-6965, +38 (044) 238-6966
  салон        Новости   Продукция   Статьи   О компании   Ссылки
 

  Tri-Vista
  A3.2 Series
  A3.2 Amp
  A3.2 CD Player
  A3.2 PreAmp
  A3.2CRPowerAmp
  A3.2 Tuner

  A5 Series
  kW Series
  A308 Series
  MonoAmp
  A324 DAC


<< назад

  
назад к Musical Fidelity

Серия А3.2

A3.2 интегральный усилитель

OUTPUT  
Voltage RMS 30 Volts 20Hz to 20kHz.
Peak 85 Volts.
Power 115 Watts per channel into 8 Ohms
(20.5dBW) 185 Watts per channel
into 4 Ohms
Peak-to-peak
output current		 24 Amps
Damping factor 120
Output devices
per channel		 Two
Pre-output impedance 50 Ohms
   
LINE OUTPUTS  
Total harmonic distortion 20Hz to 20kHz
Noise < 0.01%
Signal / noise ratio > 98dB 'A'-weighted
Input sensitivity for 115 Watts into 8 Ohms, 250 mV
Overload margin 26db
Channel separation 70db typical
Frequency response 20Hz to 20kHz, +0, -0.2dB
   
PHONO INPUT  
Frequency response reference, IEC RIAA, > See graph below
Signal / noise ratio > 94dB Moving Magnet 'A'-weighted. > 88dB Moving Coil 'A'-weighted.
Input sensitivity 2.5mV Moving Magnet
350µV Moving Coil
Input impedance 47k Ohms
Overload margin 26dB
Input Five pairs line level RCA connectors. One pair phono (MC or MM, switchable) RCA connectors.
Output

Two amplifier channels via one pair per channel binding posts. One pair RCA audio outputs controlled by the volume. One pair RCA tape record fixed line level output.

Power requirement

100 / 115 / 230Volts AC 50 / 60Hz (factory pre-set)
400 Watts maximum into 8 Ohms

A3.2 CD PLAYER

DAC architecture 24 bit Delta-Sigma (Bitstream) Dual differential
8x oversampling
Disc mechanism Sony
Upsampling 96kHz
Frequency response 10Hz to 20kHz +0 / -0.2 dB
Signal / noise ratio > 115dB 'A' weighted
Total harmonic distortion < 0.006% 10Hz to 20kHz
Total correlated jitter < 170 pS
Channel separation > 100dB 20Hz to 20kHz
Linearity < 0.2dB down to -90dB
Audio output at digital 0dB level 2.14VRMS at 1kHz nominal
Analog output One pair RCA connectors
Analog output impedance 50 Ohms
Digital outputs One optical(Toslink)
One S/PDIF (RCA connector).
Power requirements 100 / 115 / 230V AC 50 / 60Hz
(factory preset) 15 Watts
Dimensions
(approximate)
 440mm, 17.3 inches wide.
102mm, 4 inches high including feet.
375mm, 14.8 inches deep including terminals.
Weight 6kg, 13.2lbs unit only,
un-boxed.
8kg, 17.6lbs in
shipping carton.
Standard accessories Remote control handset (universal type). Two batteries (SUM-4, AAA, LR03). IEC type mains lead.
A3.2 предварительный усилитель

OUTPUT
  
Voltage RMS, maximum > 27 Volts
Power, maximum > 3.5 Watts
Peak-to-peak
output current		 0.3 Amps
Impedance 50 Ohms
Frequency response 20Hz to 20kHz ±0dB
10Hz to 100kHz +0, -2dB,
   
LINE INPUTS  

Total harmonic
distortion and noise,
20Hz to 20kHz

 > 0.006%
(5 Volts output, maximum volume)
Signal / noise reference
for 1 Volt RMS output
 101dB ('A' weighted, at half volume)
Input sensitivity for 1 Volt RMS output 240mV
Input impedance 47k Ohms
Gain at maximum
volume		 12.5dB (4.2 times)
Overload margin 31dB
Channel separation > 85dB typical at 1kHz, maximum volume
   
PHONO INPUT  
Frequency response
reference IEC RIAA		 See graph below.
Signal / noise reference
for 1Volt RMS output		 > 94dB Moving Magnet,
('A'-weighted, at half volume).
Input sensitivity for 1 Volt RMS output > 83dB Moving Coil,
('A'- weighted, at half volume).
Input impedance 2.5mV Moving Magnet.
350µV Moving Coil.
Overload margin 47k Ohms
31dB
Inputs Five pairs line level via RCA connectors. One pair phono
MM / MC switchable via RCA connectors.
Outputs One pair RCA connectors main output controlled by volume.
One pair RCA connectors tape record line level output.
Power requirements 100 / 115 / 230V AC 50 / 60Hz (factory preset). 20 watts maximum.
Weight 12.5 kg (27.5 lbs) unit only, unboxed. 14.5 kg (31.9 lbs) in shipping carton.
Dimensions 440mm (17.3) inches wide. 100mm, 3.9 inches high including feet. 410mm, 16.1 inches deep including terminals.
Standard accessories IEC type mains lead. Remote control handset (universal type). Two batteries (AAA, MN2400, LR03).
 A3.2CR усилитель мощности

OUTPUT  
Voltage RMS 32 Volts 20Hz to 20kHz.
Peak 90 Volts
Power output
 Single or both channels driven
130 Watts per channel into 8 Ohms (21dBW). 225 Watts per channel into 4 Ohms
Peak-to-peak
output current		 72 Amps
Damping factor 170
Output devices
per channel		 Six
Total Harmonic
Distortion + noise		 0.004% at 1kHz up to 90% power, into 8 Ohms. < 0.01% 20Hz to 20kHz into 8 Ohms
Intermodulation distortion 0.003% at 12.5 Watts into 8 Ohms
Frequency response

20Hz to 20kHz ±0dB
10Hz to 100kHz +0 / -1.5dB

Channel separation > 89dB 20Hz to 20kHz
Audio gain 30dB (31.5 times) nominal
   
INPUT
Input impedance 31K Ohms
Input sensitivity For full power output into 8 Ohms, 1.02 Volts
Signal / noise ratio,
reference full power output		 120dB 'A'- weighted
Inputs One pair RCA connectors, selectable from the front panel
Outputs Two amplifier channels via two pairs of speaker binding posts per channel.
One pair RCA loop output sockets.
Power
requirements
 100 / 115 / 230V AC, 50/60Hz
(factory preset).
450 Watts maximum into 8 Ohms load. 45 Watts idle.
Dimensions 440 mm (17.3 inches) wide.
100 mm (3.9 inches) high
including feet.
389 mm (15.3 inches) deep including terminals
Weight 15.5 k (34.1 lbs) unit only, unboxed.
18 kg (39.6 lbs) in shipping carton.
Standard
accessories		 IEC type mains lead.
A3.2 тюнер

Tuning range
 87.5 MHz to 108 MHz in 50 kHz steps
Aerial (antenna)
impedance
 75 Ohms, coaxial
Usable sensitivity, mono
 13 dBf
50dB quieting sensitivity
 Mono 19 dBf
Stereo 42 dBf
Alternate channel
selectivity
 55 dB ±400 kHz
Image rejection, 98 MHz
 > 92 dB
Intermediate frequency
 10.7 MHz
IF rejection, 98 MHz
 > 95 dB
Adjacent channel
selectivity, IHF
 52 dB
Pilot suppression, IEC
 30 dB
Subcarrier suppression
 32 dB
Audio output at 1kHz,
75kHz deviation
 500 mV
Audio frequency
response

30 Hz to 15 kHz ± 1 dB

Total harmonic
distortion
0.5 % at 75 kHz deviation
Stereo separation
at 1 kHz
 > 38 dB
Signal / noise ratio
 Mono > 68 dB
Stereo > 65 dB
Power requirements
 100 / 115 / 230 Volts AC ~ 50Hz (factory pre-set). 10 Watts.
Dimensions
(approximate)
 440mm (17.3 inches) wide.
100mm (3.9 inches) high
including feet.
400mm, (15.75 inches) deep including terminals.
Weight
 5 kg (11lbs) unit only, un-boxed.
7 kg (15.4lbs) in shipping carton.
Standard accessories
 Remote control handset (universal type). Two batteries (type SUM-4, AAA, LR03). IEC mains lead. 75 Ohm coaxial aerial (antenna) connector.



   Новости   Продукция   Статьи   О компании   Ссылки

МЕТА - Украина Rambler's Top100